USD
Company news
How to Fill a PCP Compressor
How to Fill a PCP Compressor
A power compressed air is compressed using special pump compressors and a manifold of related devices.pcp compressor A number of models of these compressors are available with high-energy outputs. The pressure is measured in pounds per square inch or PSI and most commonly used in residential applications. A high-end P in air compressor has more power and more capacity than its low-priced counterparts. These highly functional and impressive p a compressor is capable enough to suffice different power needs and are able to operate in noise-filled environments. These well-built electrically operated air compressors are generally equipped with a water-misting system and come in various models with specific voltage requirements.
One of the most common problems with the old p a compressor is that it does not auto purge when the moisture level falls below the preset level.pcp compressor pcp compressor This could easily be resolved by following the steps mentioned below. If your compressor came with auto purge switch, then it means that you need only to press a button when you start your machine to automatically purge the moisture. However, you may want to check whether the switch is available as an upgrade in order to get the best result. Some of the newer models of p or compressors have the auto purge switches as standard features and all you need to do is add a pressure switch to them.
To purge the moisture before starting the machine, you should fill the storage tank completely with water and then activate the machine.pcp compressor pcp compressor Ensure that there is no moisture in the storage tank and fill up to the indicated marker. After getting the gauge reading, lower the ps into the recommended range of 0.3000 psi in approx. water. Then, switch on the switch located close to the fill button to initiate the filling of the compressor's storage water.
The next step is to switch on the air guns. Set one of the two air guns to shoot at the air bubble to pop it. Use both of the guns simultaneously to pump up the air in the tank. The resulting suction created by the high pressure of the compressed air will pull out the dust and other debris from inside the storage tank. Repeat this procedure as and when necessary to ensure that the moisture content is thoroughly flushed out of the p cp tanks.
After ensuring that the water level in the storage tank is within the suggested mark, you can now fill up the tank with the water needed for powering your p cp or nomad ii portable pcp compressor. When you are completely done, you should switch on the trigger and release the air tank filler. The suction created by the compressed air will pull out all the dust and other debris inside the air tank. Repeat this process as many times as necessary to fill up the tank.
Last but not the least; you have now successfully powered your compressor. To finish off, you should switch on the trigger and release all the remaining compressed air in the tank. When the compressed air is completely expelled, you will now be able to remove the empty tank from the system. You can now use your portable p is air gun to shoot down any target without any difficulty.
0users like this.
